Compatible-systems 5.4 Manual de usuario descargar pdf (Pagina 90)

84 Chapter 4 - AppleTalk Routing & Bridging

v Note: In transitional routing installations, the same range of possible

AppleTalk network numbers is used by both Phase 1 and Phase 2. Care must

be taken to avoid network number conflicts in these installations.

> Phase 1 Routing/Off

These radio buttons control whether AppleTalk Phase 1 packets received by

a member interface of the AppleTalk Phase 1 Bridge Group are passed on for

AppleTalk routing.

• If set to Phase 1 Routing, then AppleTalk Phase 1 packets received on a

member interface of the AppleTalk Phase 1 Bridge Group which cannot

simply be bridged to another member interface of the group are passed

on for AppleTalk routing.

• If set to Phase 1 Off, then AppleTalk Phase 1 packets received on a

member interface of the AppleTalk Phase 1 Bridge Group which cannot

be bridged to another member interface of the group are dropped. This

setting means that further AppleTalk configuration information is not

required for the AppleTalk Phase 1 Bridge Group.

Phase 1 Seed Status

One of the functions which routers perform in AppleTalk internetworking is

setting the AppleTalk network number for each network segment. A router

which sets the network number for a segment is said to have “seeded” the

network.

• Seed means the router will listen for an AppleTalk Phase 1 network

number being set by another router on the segment(s) which are members

of the AppleTalk Phase 1 Bridge Group and use this number if it exists.

If it doesn’t discover a number in use, the router will use the configured

AppleTalk Phase 1 Net # (discussed below) to set the Phase 1 network

number for the segment(s). It will also assign the configured Phase 1

Zone name to the segment(s).

• Non-Seed means the router will listen for an AppleTalk Phase 1 network

number being set by another router on the segment(s) which are members

of the AppleTalk Phase 1 Bridge Group and use this number if it exists.

If it doesn’t discover a number in use, the router will wait indefinitely

until a number is set by another router on the segment(s).

• Auto-Seed means the router will listen for an AppleTalk Phase 1

network number being set by another router on the segment(s) which are

members of the AppleTalk Phase 1 Bridge Group and use this number if

it exists. If it doesn’t discover a number in use, the router will

auto-generate a valid number using its routing tables.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 312 313

Sin comentarios

Compatible-systems 5.4 Manual de usuario Pagina 90