Compatible Systems MicroRouter 1200i Manual de usuario descargar pdf (Pagina 15)

GORAMO – Janusz Górecki

MultiLink Router and MikroRouter

www.goramo.com.pl

[email protected]

age 15 from 41

4.6.2 Configuring ports Eth0, Eth1, Eth2, Eth3, Eth4, Eth5

Please note that the Ethernet ports usually do not require additional configuration. Of course, the

operation should not be confused with the configuration of network interfaces eth0 and eth1, etc.

Routers are equipped with a number of Ethernet interfaces. Number of interfaces ranging from one

to six

, depending on the version of the router. For each of the built-in network interfaces, we can

determine the MAC address and mode of operation - defining the speed and mode of action of the

interface (at the moment does not apply to the interface connected to the USB port). If you do not want

to set your own MAC address for Ethernet interfaces, the interfaces will use MAC addresses from the

pool reserved by GORAMO.

To configure these settings, go to the tab Devices, and in the line representing interests us interface

on the right side of the to select the Configure tab. You'll see a form with the following parameters:

Current MAC Address --- Currently assigned MAC address

Overwrite MAC

Address

[X] The question is whether we want to overwrite the

factory MAC address

MAC Address 00:00:00:00:00:00 This field allows you to enter the MAC address,

which if you select Overwrite MAC Address is

replaced by a factory address.

All enabled Interface negotiates optimal (fastest) mode

Force 1000 Base T Full

Duplex

Force 100Mbits, Full Duplex

Force 1000 Base T Half

Duplex

Force 100Mbits, Half Duplex

Force 100 Base T Full

Duplex

Force 100Mbits, Full Duplex

Force 100 Base T Half

Duplex

Force 100Mbits, Half Duplex

Force 10 Base T Full

Duplex

Force 10Mbits, Full Duplex

Media Technology

Force 10 Base T Half

Duplex

Force 10Mbits, Half Duplex

NOTE: If you use optical interfaces eth0 and eth1, manually select a field value of "Media

Technology" as Force 100 Base T Full Duplex.

For all the Ethernet interfaces you can enter your login with the username and password PPPoE, and

of course IP addresses. These settings are available from the Interfaces tab.

4.6.3 WLAN Configuration

The device allows the WLAN configurations, if they are connected to his WiFi card. When you

connect your WiFi in the tab devices appears the WLAN0 device and in the interfaces tab interfaces

WLAN0. Connecting the next WiFi devices will result in the appearance of interface wlan1, wlan2. At

present, there may be problems with the order of equipment (eg remove the device wlan0, wlan1

device is renamed wlan0).

WLAN device visible under the name wlan0, we can set up after clicking „Configure” in the

line representing the WLAN Devices tab.

Eth 4 and 5 are based on internal PCI bus. If you need even more ports Eth, it can be obtained by connecting a

USB converters: DUB-E100 F my D-Link. "

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 40 41

Comentarios a estos manuales

Sin comentarios

Compatible Systems MicroRouter 1200i Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Compatible Systems MicroRouter 1200i