Compatible Systems MicroRouter 1200i Manual de usuario descargar pdf (Pagina 34)

GORAMO – Janusz Górecki

MultiLink Router and MikroRouter

www.goramo.com.pl

[email protected]

age 34 from 41

Upgrading the operating system software is achieved through the program RedBoot over port Eth0

as follows: shortly after the RedBoot startup is running, which pre-boot Linux stops at 10 seconds,

giving the possibility, among other things, delete the old files and download new. Bold in the

following procedure, indicated the place in which to change or enter the appropriate value for its own

network.

Attention!!!

Before deleting files by command fis delete you should check whether loading of files from server

TFTP work; the best command is:

load -r -b 0x800000 gml*.img – if the file has been loaded,

the following message will be displayed:

Raw file loaded ………. It was it been possible then to

begin lower described procedure of actualization.

The procedure was it been possible to shorten to marked with blue color commands, if the setting of

server TFTP will agreed from settings in RedBoot, in peculiarity: Default server IP address:

192.168.0.45

RedBoot(tm) bootstrap and debug environment [ROM], Built Dec 18 2007

Platform: Router MultiLink (XScale) BE

RAM: 0x00000000-0x08000000, [0x00024320-0x01fcd000] available

FLASH: 0x50000000 - 0x51000000, 128 blocks of 0x00020000 bytes each.

=Executing boot script in 10.000 seconds – enter ^C to abort

RedBoot> fis unlock –f 0x50060000 –l 0xfa0000

RedBoot> fis delete router

RedBoot> load -r -b 0x30000 armeb*

RedBoot> fis create router

RedBoot> reset

... Resetting.

If everything went correctly there should be booting

You can change the address of the tftp server to another if it does not correspond to the factory setting,

from within RedBoot

RedBoot> fconfig -i

Initialize non-volatile configuration - continue (y/n)? y

Run script at boot: t

Boot script:

Enter script, terminate with empty line

>> fis load router

>> exec

>> <───┘

Boot script timeout (1000ms resolution): 10

Use BOOTP for network configuration: f

Gateway IP address: 192.168.0.1

Local IP address: 192.168.0.35

Local IP address mask: 255.255.255.0

Default server IP address: 192.168.0.45

Console baud rate: 115200

GDB connection port: 0

Force console for special debug messages: false

Network debug at boot time: false

Default network device: npe_eth0

Update RedBoot non-volatile configuration - continue (y/n)? y

... Unlock from 0x50fe0000-0x51000000: .

... Erase from 0x50fe0000-0x51000000: .

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41

Comentarios a estos manuales

Sin comentarios

Compatible Systems MicroRouter 1200i Manual de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Compatible Systems MicroRouter 1200i