Compatible Systems MicroRouter 900i Manual de usuario descargar pdf (Pagina 38)

38 - Preparing Tooling Hardware - Section 5 Microrouter CNC Machine User's Manual

Left: Turn

clockwise

to tighten

clamp.

Tools required:

• 5mm allen key (supplied).

5: Refitting the Laminate Trimmer to the

Machine Head

Never open the safety

guard door and enter

the working area when

the spindle or machine

axes are moving.

Safety First !

continued...

To refit the laminate trimmer:

1) Check that the clamping bracket hole is loose enough to accept

the laminate trimmer body. After fitting the tool, carefully lower

the laminate trimmer vertically into the clamping bracket, taking

care not to hit any cutting tool on any machine fittings. Check

that the laminate trimmer body is pushed fully into the clamping

bracket.

2) If necessary, lift up the front brush guard to gain access to the

allen bolt, located on the front left side of the clamping bracket.

Using a 5mm allen key, tighten the clamping bracket bolt by

turning it in an clockwise direction. Check that the laminate

trimmer is held securely.

Location

Look at front of machine

head.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 93 94

Sin comentarios

Compatible Systems MicroRouter 900i Manual de usuario Pagina 38