Compatible Systems MicroRouter 900i Manual de usuario descargar pdf (Pagina 69)

Section 9 - Technical Support - 69Microrouter CNC Machine User's Manual

9: Troubleshooting

The part is being cut at an incorrect depth :

Check the validity of the following:

1) The Z value entered in the tool length offset.

2) The Z value entered in the workpiece offset file.

3) The number (size) used for defining the depth of cut used in your

CNC program.

4) The sign (+ or -) used for defining the depth of cut used in your

CNC program. If your workpiece datum is aligned with the upper

surface of your billet, any Z values cutting into this billet will have

a minus sign.

The machine begins cutting the part at the wrong location :

Check the X and Y values entered in the workpiece offset file.

Incorrect registration of tool offsets, when using multiple tools

of the same diameter :

All tool offset data is saved in the tooling library according to the tool

diameter, rather than the tool number used with the machine. This

can present problems when you wish to use two or more tools of

different lengths but identical tool diameters, for example, a 4mm

roughing tool and a 4mm finishing tool. Only one tool offset can be

registered, since the standard tooling library only contains one 4mm

tool. In this example, separate entries must be created in the tooling

library for both the 4mm roughing and finishing tools, then each tool

added to the machine tooling window, to allow separate tool offset

values to be registered.

Failure of the laminate trimmer motor to start :

Should the laminate trimmer motor fail to start, check that the prongs

on the mains power cord plug are making good contact inside the

outlet. Also, check for blown fuses or indications within your control

software.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 93 94

Sin comentarios

Compatible Systems MicroRouter 900i Manual de usuario Pagina 69